To winterize an RV, you must drain the water systems, bypass the water heater, and pump non-toxic RV antifreeze through the plumbing or blow out the lines with compressed air.

1. Drain the Water Systems

  • Empty holding tanks: Dump and flush your black and gray wastewater tanks at an approved station.
  • Drain the fresh water tank: Locate the fresh tank drain valve or cap under the RV and let it empty completely.
  • Drain the water heater: Turn off all gas and electric power to the water heater, let it cool, open a hot water faucet to relieve pressure, and remove the drain plug or anode rod.
  • Open low-point drains: Remove caps or open valves on the hot and cold low-point water lines underneath the RV.
  • Open all faucets: Open every hot and cold indoor and outdoor faucet, showerhead, and the toilet flush valve to let gravity drain the lines.

2. Bypass the Water Heater

  • Turn the valves on your water heater (2-valve, 3-valve, or management panel system) into bypass mode.
  • This prevents expensive RV antifreeze from filling the 6-to-10-gallon water heater tank.

3. Add RV Antifreeze

You can protect your lines using either the antifreeze pumping method or the compressed air blowout method (or combine them):

  • Antifreeze Method:
    • Connect a siphoning hose to the inlet side of your water pump and place it into a jug of non-toxic pink RV antifreeze.
    • Turn on the water pump.
    • Go to each faucet (hot and cold), starting with the one furthest from the pump, and let it run until bright pink antifreeze appears.
    • Do not forget the outdoor shower, exterior spray ports, and the toilet flush lever.
    • Pour about one cup of antifreeze down each sink and tub drain to protect the P-traps, and leave a small amount in the toilet bowl to keep the seal moist.
  • Air Compressor Method:
    • Attach a blowout plug adapter to your city water inlet and regulate your air compressor to 30–40 PSI (never exceed 60 PSI).
    • Open each fixture one by one until all water is blown out, then pour RV antifreeze into all P-traps and the toilet.

4. Protect Interior and Exterior Components

  • Appliances and interior: Remove all food, trash, and valuables. Clean the refrigerator/freezer, turn it off, and prop open the doors with a box of baking soda. Turn off the main electrical breaker.
  • Batteries: Disconnect or remove house and engine batteries, or plug the RV into shore power and use a battery tender.
  • Exterior and tires: Cover roof vents or exhaust outlets if needed, and park the tires on wood planks (like 2×8 boards) rather than bare ground or asphalt, covering them with specialized RV tire covers.